Your Shopping Cart Contents
No Products Found in Your Shopping Cart
Read What Some of Our Happy Customers Have to Say
August 6th, 2008 by Mark M.
Product: Woodworker II
Rating: 5 of 5 stars
Hello--
You guys probably get kudos all of the time. I'm a beginner woodworker with a limited shop and budget. However, I sprung for a woodworker 2 with a standard kerf because you advertised that the edges would be good enough to glue without additional steps.
This is my first project. A few passes through the table saw, and sure enough the pieces for the tabletop were good enough to glue. Crosscuts are very clean. All of my joints are tight. I did experiment with a router pattern bit and a straight edge and in my view your saw blade yielded a superior result.
But you probably knew all of that.
Thanks
Mark Eisenbies
February 23rd, 2006 by David S.
Product: CM10806105
Rating: 5 of 5 stars
Dennis, I called about the wobble to the chopmaster blade yesterday. I went home and checked the arbor and the backplate on the radial arm saw. It was the backplate. It had a burr. Fixed the back plate and the blade is as straight and flat as an arrow. No more wobble. Thanks for the advice.
May 19th, 2008 by joel k.
Product: Forest woodworker II / Custom
Rating: 5 of 5 stars
14" Woodworker II 40 tooth and custom 20 tooth woodwrker blades. These blades have performed flawlessly even after 5 months of production cutting in my shop. The 20 tooth custom blade has cut approx. 10,000 lineal feet of 12 quarter poplar half @ 45 degrees. The 40 tooth blade has cut more than a truck load of 3/4" cdx plywood. The longevity of these blades is un-matched.
Respectfully
Joel Keever
