Hello--
You guys probably get kudos all of the time. I'm a beginner woodworker with a limited shop and budget. However, I sprung for a woodworker 2 with a standard kerf because you advertised that the edges would be good enough to glue without additional steps.
This is my first project. A few passes through the table saw, and sure enough the pieces for the tabletop were good enough to glue. Crosscuts are very clean. All of my joints are tight. I did experiment with a router pattern bit and a straight edge and in my view your saw blade yielded a superior result.
But you probably knew all of that.
Thanks
Mark Eisenbies
From: Mark M.
