Your Shopping Cart Contents

April 9th, 2013 by Curtis

Product: 10x40T Woodworker II

Rating: 5 of 5 stars

I plan on using this on a Bosch Portable Saw. I used to be a cabinetmaker. When you have had the best it is hard to settle for anything less. Thank you.

January 4th, 2012 by Alan M.

Product: Table and chop blade

Rating: 5 of 5 stars

I have been running a ten inch #1 grind blade on my Unisaw for the past year and have made thousands of cuts in making boxes. It is finally dull, but has outlasted the Freud blades by three or four times.
The Chopmaster on my Mekita saw is ideal for veneer and I can even cut single sheets with no splinters.
I am completely sold on your blades. They are worth every penny. Keep up the good work.

August 6th, 2008 by Mark M.

Product: Woodworker II

Rating: 5 of 5 stars

Hello--
You guys probably get kudos all of the time. I'm a beginner woodworker with a limited shop and budget. However, I sprung for a woodworker 2 with a standard kerf because you advertised that the edges would be good enough to glue without additional steps.
This is my first project. A few passes through the table saw, and sure enough the pieces for the tabletop were good enough to glue. Crosscuts are very clean. All of my joints are tight. I did experiment with a router pattern bit and a straight edge and in my view your saw blade yielded a superior result.
But you probably knew all of that.
Thanks
Mark Eisenbies